RECOMMENDED TURBO PASCAL BOOKS BY BOB DALTON ------------------------------ The books below, listed in no particular order, are ones that I have found to be very valuable in helping me program with Turbo Pascal from Borland and I use them often: 1. Turbo Pascal 6 Disk Tutor by Werber Feibel ISBN 0-07-881738-2 Remarks: This book taught me how to program with TP and is in constant, dog earred, use on my desk. Note: Comes with a companion disk will all source code shown in the book! 2. Programming with Turbo Vision by Blake Watson ISBN 1-55851-399-X Remarks: This book opened my eyes and made me appreciate what Turbo Vision could do for me. Note: Comes with a companion disk will all source code shown in the book! 3. PC Intern by Michael Tischer ISBN 1-55755-145-6 Remarks: All the nitty gritty hard core stuff you could ever want to know about the PC (up to Pentium) and DOS (up to version 6.2) Note: Comes with a companion disk will all source code shown in the book! 4. PC Magazine Turbo Pascal 6.0 Techniques and Utilities by Neil J. Rubenking ISBN 1-56276-010-6 Remarks: Taught me a lot about advanced procedures and efficient methods of programming. Note: Comes with a companion disk will all source code shown in the book! 5. Mastering Turbo Pascal 6.0 by Scott D. Palmer Remarks: Next step up from the Tutor book above and I use it ALL the time. ISBN 0-89588-675-8 Where can you get these books? I would recommend from CompuBooks out of Cedar Creek, Texas. There prices tend to be about 15% lower then normal retail and they give good service. They can be reached at their order line at 1-800-880-6818 or 1-512-321-9652. You can also buy books from them on CompuServe. Just type GO CBK. There Internet address is: 70007.1333@CompuServe.com There mailing address is: CompuBooks Route 1, Box 271-D Cedar Creek, Texas, 78612-9733 USA